46
INSTRUCTION MANUAL
_____________________________________________________________________________________________________________________
15. Maintenance and small repairs
1.
Keep the balance clean.
2.
Take care, for during the operation some impurities may enter under balance
base and into sensors vicinity. In case of impurities finding remove them.
3.
In case of improper operation due to short power failure, switch off the balance
by unplugging the power cable from the socket, and plug it again after a few
seconds.
4.
The message “Err-b”, displayed after switching on the unloaded balance,
indicates the balance sensor mechanical damage.
5.
All repairs must be performed by the authorized personnel.
6.
To perform the repair contact the nearest service point.
Emergency messages:
Message
Reason
Recommendation
C-1
...
6
(over
1min.)
autotest negative result
contact the service
balance loaded during turning on
remove load from the
balance
balance sensor mechanical failure
contact the service
l
balance mechanical failure
contact the service
H
balance overload
remove load from the
balance
balance mechanical failure
contact the service
indicator does
not work
balance unstable,
base vibrations,
air blasts
place the balance in
location, assuring the
indications stability
balance damage
contact the service
-
-
-
-
-
-
tare setting not finished
contact the service
-
-
tare setting unsuccessful
(too low load or B/G pressed)
zero the balance or pres
B/G again
-
-
zeroing with too high load
set the tare
