Q7B300 Qseven Module Development Board
Board and Pin Assignments
27
LAN
USB
2.5.20
Ethernet and USB 3.0 Ports (CN37 and CN41)
The board is equipped with high performance plug and play Ethernet interface fully
compliant with the IEEE 802.3 standard. The Ethernet port uses RJ-45 connector.
Connection can be established by plugging one end of the Ethernet cable into this RJ-45
connector and the other end to a 1000/100/10-Base-T hub.
The lower double-deck USB connector is USB 3.0 and USB 2.0 compliant for connecting
to any USB peripheral, such as keyboard, mouse or scanner.
CN37:
The USB 2.0 port 1 signals on CN41:
Note
1. Select to route USB_P1 to CN37 or to CN41 with jumper JP5, see
section 2.4.5.
2. Select operation mode (Host mode or OTG mode) supported by USB
port 1 with jumper JP6, see section 2.4.6.
Pin LAN Signal
Pin
LAN Signal
L1
G
L5
GBE_MDI2-
L2
GBE_MDI0-
L6
GBE_MDI1-
L3
G
L7
G
L4
G
L8
GBE_MDI3-
A
Activity link LED
OFF: No link
Blinking: Link established; data activity detected
B
Speed LED
Orange: 1GMbps data rate
Green: 100Mbps data rate
OFF: 10Mbps data rate
Pin USB Signal
Pin
USB Signal
1
+5V
10
+5V
2
USB_P0-
11
USB_P1-
3
12
4
GND
13
GND
5
USB_SSRX0-
14
USB_SSRX1-
6
US
15
US
7
GND
16
GND
8
USB_SSTX0-
17
USB_SSTX1-
9
US
18
US
Pin USB Signal
Pin
USB Signal
1
+5V
4
ID
2
USB_P1-
5
GND
3
