MVS900-511/512-FL
26
Hardware Installation
Step 4
Install the SO-DIMM (small outline dual in-line memory module) into the socket and
push it firmly down until it is fully seated. The socket latches are clipped on to the
edges of the memory module.
Step 5
After installing the memory modules, please close the heatsink cover back to the
chassis and fasten all screws.
2.3 Installing the Hard Disk Drive
The MVS900 Series offers a convenient drive bay for users to install HDD. The system offers
users two 2.5” Hard Disk Drives for installation. Please follow the steps:
Step 1
Turn off the system.
Step 2
Disconnect the power connector.
Step 3
Unscrew and remove the backplane of the HDD bay on the backside.
Step 4
Unscrew the thumbscrew and separate the HDD2 bracket from the HDD bay.
Step 5
Unscrew the HDD1 bracket and separate the HDD1 bracket from the HDD bay.
Summary of Contents for MVS900-511-FL Series
