AXIOMATIC AX180800, User Manual

Page: 48 / 72

UMAX180800, 20 Thermocouple, 2 RTD, 4 Inputs, 6 Relays Dual CAN Controller Version 1 Page: 48-71
Figure 17: Screen Capture of Default Setpoints
Table 40. Default Relay Output Setpoints
Name Range Default Notes
Relay Output Type Drop List 0, Output Disabled Refer to Section 3.6
Relay Toggle Rate
0…60000
500 Refer to Section 3.6
Relay Control Source Drop List 0, Control Not Used Refer to Table 5
Relay Control Number Depends on Control Source 1 Refer to Table 5
Relay Unlatch Source Drop List 0, Control Not Used Refer to Table 5
Relay Unlatch Number Depends on Control Source 1 Refer to Table 5
Relay Enable Source Drop List 0, Control Not Used Refer to Table 5
Relay Enable Number Depends on Control Source 1 Refer to Table 5
Relay Enable Response Drop List 0, Enable When ON Refer to Section 3.6
Relay Override Source Drop List 0, Control Not Used Refer to Table 5
Relay Override Number Depends on Control Source 1 Refer to Table 5
Relay Override Response Drop List 0, Enable When ON Refer to Section 3.6
Relay Override State Drop List 0, Override State ON Refer to Section 3.6
Relay Response Delay Drop List 0, Disabled Refer to Section 3.6
Relay Delay ON Time
0…60000
0 Refer to Section 3.6
Relay Delay OFF Time
0…60000
0 Refer to Section 3.6
4.3.6 Math Function Block Setpoints
The Relay Output setpoints are defined in Section 3.7.Refer to that section for detailed
information on how these setpoints are used. The screen capture below in Figure 18 displays
the available setpoints for each of the Thermocouple Inputs. Table
41 below highlights the
allowable ranges for each setpoint.
*Please note: To show the setpoints, the Math Enabled setpoint was changed from its default
value.