UMAX141520 Version 1B
11-19
3.6 Start/Stop Logs
Press ‘s’ to start or stop the debug logs. Starting the debug logs will print the supplied voltage to the Unit
and Ethernet and Automotive Ethernet Link status on Tera Term, as per the Log Timing configuration. i.e., If
Log Timing is 1 Second, the converter will print the debug logs every second.
Pressing ‘s’ again will stop the
logs.
Figure 9 Status Log
3.7 Reboot the Controller
Press ‘r’ to reboot the converter. This will simply restart the converter. Rebooting the converter will not
change the Mode or Speed of the converter. This option is useful to restart the converter through Tera
Term.
3.8 Activate bootloader
Press ‘b’ to activate the bootloader. To activate the bootloader please enter the password: “StartBL”.
As shown in the picture below, it will Reboot the convert and the Bootloader will be started. The bootloader
ID will be printed, and the bootloader will be activated. Bootloader Menu will give options to load a new
Firmware file, to read the current Firmware file, or to reboot the convert to close the bootloader and start the
Firmware again.
