Operation Instructions | EoC 1-01 | Ethernet over Coax
10
2018-02-04 | Technical improvements, changes in design, printing- and other errors expected.
2. Installation and commissioning
1. Connect the router with the enclosed Ethernet cable to one of both RJ-45 LAN sockets of the EoC modem.
2. Connect the EoC socket to the available antenna network structure
(see example 1 to 4).
There are several ways to feed the IP data into the existing antenna network structure.
– via a return channel capable antenna socket in the distribution network (see example 1 or 3)
– via the passive terrestrial input of the SAT multiswitch or the passive terrestrial input of a distribution
structure (see example 2 or 4).
3. Connect your computer using the enclosed Ethernet cable to one of both RJ-45 LAN sockets of the second
EoC modem.
4. Then connect the EoC modem using the EoC-F socket to the return channel capable antenna socket (see
example 1 or 3) or to the
return channel capable
EoC combiner (see example 2 or 4).
Repeat step 3 + 4 for further commissioning of EoC 1-01.
After all connections have been established, the EoC devices can be switched on by means of the mains switch
and the connected devices (PC, laptop etc.) can be booted up.
The LEDs Power, EoC, LAN and WiFi are lit and the data transfer is established.
Notes:
∂
Up to two networkable devices can be connected to one EoC modem.
∂
Additionally, a TV or radio device can be connected to the TV-F socket of the EoC modem.
