Initialization of a new slave reader
A programming tag is referred to the DESFIRE EV2 tag that was added to the system after initially
setting the master reader as master.
1. Connect and commission the reader.
2. If not already done, connect and commission the reader
3. Enter programming mode
4. Navigate to menu
Options > Operating mode and select Slave.
5. Select
Pair system.
6. Present the Programming tag to the reader until
Hold tag disappears.
7. Set time/date and active buttons for radio keys.
8. Exit the programming mode
9. Follow the instructions in
Maintenance/ administration of a SOLO-system
Convert a slave reader to a master reader
If the master reader needs to be replaced, any slave reader can be set as the new master reader.
1. Replace the master reader with a slave reader from the system.
2. Enter programming mode
The programming mode is entered by pressing the programming button (the rightmost
round button) and entering of the programming code. (Default set to 112233).
3. Navigate to
Options menu -> System -> Operating mode and select Master.
4. Verify that the settings in the new master reader are correct.
5. Exit the programming mode
6. To replace a slave reader, see
8 (9)
ManualA66 SOLO
