Jumpers for alarm trigger
DL 12 LED Status
Flashes during operation.
Rapid flash during trigger or delay.
Programming
Press and hold
P1 for approximately 2 seconds. The status LED should shut of and
configuration LED 1 should turn on. The display will show the preset delay before
the alarm is activated. The red dot by the display indicates that the delay is in
minutes
l
A short press on
P1 moves to the next setting.
l
A long press on
P1 until Status LED 13 changes switches the function of P2,
see below.
l
P2 is used to increase or decrease the value. If status LED 13 is lit, P2 is
used to decrease the value, otherwise
P2 is used to increade the value.
Settings
1.
Delat
before the alarm is activated
Configuration LED 3 is lit up.
0 sec. to 5 min., factory set to 0 sec.
5 (17)
Manual UDR Plus
