AVYCON AVR HT Series, Manual, Page: 79 / 135

Alarm Management
71
camera) in 10 seconds. If there is another motion detected during this period, it
will be considered as a continuous movement; otherwise it will be considered as
a single motion.
Abandoned object: Alarms will be triggered if there are articles left in the
pre-defined detection area.
Missing object: Alarms will be triggered if there are articles missing in the
detection area drawn by the users.
Object Detection Configuration:
③
④
Drag the camera image to set the motion area. You can set more than one
motion area. Click “All” to set the whole camera image as the motion area. Click
“Reverse” to swap the motion area and the non-motion area. Click “Clear” to
clear all the motion areas.
Click “Apply” to save the settings. Click “Processing Mode” to go to the
alarm handling configuration interface of the motion alarm.
②
③
Enable or disable “Record”, “Snapshot”, “Push”, “Alarm-out”, “Preset”,
“Buzzer”, “Pop-up Video” and “E-mail”. The alarm handling setting of motion
alarm is similar to that of the sensor alarm (see 9.1 Sensor Alarm for details).
Click “Apply” to save the settings. You can click “Motion Settings” to go to
the motion configuration interface.
①
②
Click Start

Settings

Camera

Intelligent Analytics

Object Detection
to go to the following interface.
Select the camera, enable the object detection and set the duration and
detect type. There are two detect types: Abandoned object and missing object.
③
④
Select the alarm area. A maximum of 4 alarm areas can be set.
Draw the alarm area of the object detection. Refer to the interface as
shown above. Check “Draw Area” and then click around the area where you
want to set as the alarm area in the image (the alarm area should be a closed
area). Uncheck the “Draw Area” if you finish the drawing. Click the “Clear” button
to delete the alarm area.
9.2.2 Motion Alarm Handling Configuration
① Click Start

Settings

Alarm

Motion Alarm to go to the following
interface.
9.3 Intelligence Alarm
9.3.1 Object Detection