AVTECH Software, Inc.
Temperature & Environment Monitoring
…
Made Easy!
AVTECH.com
Power Sensor
(RMA-PS1-SEN)
Installation Note
AVTECH’s Power Sensor monitors the on/off state of a power
source, such as main power, a UPS, surge protector or
standard wall outlet. Simply plug the Power Sensor into the
source you wish to monitor. When the power goes out, it sends
a signal to Room Alert. Install multiple Power Sensors to
generate alerts when one source fails and the back up takes
ove
r.
Power Sensor Package Contents
One (1) Power Sensor ID box
One (1) 25' speaker cable
One (1) AVTECH power adapter
One (1) Installation Note (You’re reading it now.)
The Power Sensor ID Box
Install Your Power Sensor
Step 1: Prepare the included 25' speaker cable.
Your Power Sensor comes with one end of the 25' speaker wire already
attached to its contacts, which are non-polarized. Separate and strip the
leads on the free end of the speaker cable, exposing about ¼" of wire.
Step 2: Mount your Power Sensor.
1.
Position your Power Sensor close enough to the power source that the power adapter
cord will reach. (Don’t connect power yet—you’ll do that in a later step.)
2.
Mount your power sensor with screws through the flange holes, secure it with Velcro or
simply place it on a flat surface.
Do not use this sensor in hazardous (classified) locations or life safety applications.
Right Side
Left Side
Power
LED
Power
Port
Dry Contacts
