Mako Technical Manual
V2.1.0
10
Camera cleaning instructions
Camera cleaning instructions
This chapter describes safety instructions/cautions valid for
Mako
cameras in
case of cleaning lenses, optical filters/protection glass or sensors.
Warranty
Avoiding the necessity of camera cleaning
When screwing/unscrewing the camera lens or dust cap, hold the camera with
the C-Mount / CS-Mount opening towards the floor as shown in figure 1. This
minimizes the possibility of any contaminants falling on the glass surface.
Always store cameras and lenses with dust-caps installed.
Note
•
Please read these instructions before you contact your
AVT camera dealer for assistance.
•
Ask your AVT camera dealer if you are not familiar with
the procedures described below.
www
For details about camera warranty duration and sen-
sor warranty terms, visit:
http://www.alliedvisiontec.com/emea/support/
warranty.html
Caution
Warranty precautions
•
To ensure your warranty remains in effect:
– Do not open the camera housing.
– Follow instructions described below.
– Use only optical quality tissue/cloth if you must clean
a lens or filter.
– Use only optics cleaner (60% ethyl alcohol, 40%
ether). Never use aggressive cleaners like benzine or
spirit. Such cleaners may destroy the surface.
–
Do not use compressed air which can push dust
into camera and lens.
•
AVT does not warranty against any physical damage to
the sensor/filter/protection glass or lenses.
Use utmost
care when cleaning optical components
.