AVProEdge AC-MX-88X, User Manual

Page: 19 / 49

19
Output Settings Label
- Use this to give an name/alias to your outputs (Living Room, Den, Kitchen, etc).
Note: There is a 15 character limit to this field, the name will replace the default “OUT #” throughout the rest of the WebUI (for instance the
Video Matrix tab).
Output Settings State - This drop-down has 3 settings, just like the input settings you can Enable or disable this port. In
addition you can also choose Test Pattern to enable a 1080P color bar test pattern on that output. This is helpful in verifying the
signal chain from Matrix to sync (display). To disable the test pattern, change the state back to Enabled (default).
Output Settings Video Scaling - The HDMI outputs each have 3 settings. No scaling (scaling is off), 4k to 1080P, and 8k to 4k.
WebUI: I/O Config - Output Settings
WebUI: I/O Config - Output Settings Cont.
Output Settings Signal -
The Signal Indicator on the HDMI OUTPUTS shows the current state of the connection HDMI Output.
Green means HDMI sync is detected, red means that the sync is not detected. If red verify that the output is powered on and
that the HDMI cable is properly connected to the sync and to the back of the matrix.