c. Camera Select
Up to 4 different cameras can be controlled with one IR remote Control. You can use the
camera select
buttons
[
1,2,3,4
] to select the IR channel that the remote control is using. The default camera IR channel is 1.
1.
To control a camera on first use, select camera 1 (IR channel 1) on the remote control.
2.
To control a second camera, you first need to change the IR channel stored in the camera from 1
to 2. Then do the following:
a.
First turn off the other cameras in the room you don’t want to change, to prevent that other
cameras also get changed accidentally.
b.
Select camera 1 on the remote control, because the camera is still configured to listen to IR
channel 1.
c.
Press
[*]→[#]→[F2]
to change the IR channel inside the camera to IR channel 2. The camera
will confirm this on the screen.
d.
Select camera 2 on the remote control to control this camera.
Key Combinations: (Default IR address is 1)
[*]→[#]→[F1]
Camera Address No. 1
[*]→[#]→[F2]
Camera Address No. 2
[*]→[#]→[F3]
Camera Address No. 3
[*]→[#]→[F4]
Camera Address No. 4
The Function buttons F1, F2, F3 and F4 are the colored buttons on the remote.
Figure 48: Function Buttons on Remote
d. Number Keys
The number keys are used to call presets.
Press the number
[0-9]
of the desired preset and the camera will respond accordingly (See ‘h’ on
how to set & clear presets).
e. Focus + -
1.
Push the button [manual focus] first before using the focus buttons.
2.
Focus the camera with the [+] and [–] button.
If the camera does not respond, check if the camera is set to auto-focus.
f. Auto/Manual Focus
Set the camera to 'auto focus' or 'manual focus'.
If the camera is configured to 'auto focus', the buttons [Focus + -] are disabled.
If the camera is in 'manual focus' and the
Zoom
buttons are used, the camera automatically switches
to 'auto focus'.
g. Zoom + -
Zoom the camera with these buttons.
42
Summary of Contents for CM70-IP
Page 68: ...APPENDIX B DIMENSIONS 68...