RFSoC Development Kit Getting Started Guide
Page 18
Configuring the RF-ADC in the DPD observation path
We start by enabling the ADC block for the DPD observation path in channel 1 of the Qorvo RF card,
which connects to ADC07 (Tile 3, Block 1) of the RFSoC device on ZCU111.
1. Enable ADC Tile 3 in RFSoC Explorer. Click to enter the tile.
Figure 15 - RFSoC Explorer Enabling ADC Tile 3
2.
Enable ADC23. This is the ADC block that connects to the channel 1 observation path of the Qorvo RF card.
Click OK on the warning box; you will perform ADC calibration in a later step.
Figure 16 – Enabling ADC23 in Tile 3
