Avnet MSC C10-MB-EV, User Manual

Page: 33 / 48

MSC C10-MB-EV User Manual
33 / 48
4.10.3 USB Client Connector
The USB Port 7 signals were switched to a 5 pin header, if a USB client is plugged at
X1903.
Specification:

References: X1903

Connector: single row pin header

Pin-out: Refer to Table 14

Location: Refer to chapter 4.10 USB Topology
Pin Signal Function
1 VCC_IN_CLIENT Power in
2 USB_P7_N USB port 7 negative signal
3 USB_P7_P USB port 7 positive signal
4 GND Power Ground
5 GND_SHLD Ground Shield
Table 14 USB Client Connector
4.11 Ethernet
The base board can be connected to a local area network with an Ethernet interface. The
COM Express module already provides MDI signals, so that only the transformer on the
base board required. The transformer is integrated in X702.
Specification:

References: X702

Connector: Würth 749110616 (RJ45LAN 10/100/1000 BaseT + USB 3.0)

Pin-out: Refer to IEEE Std. 802.3
[9, section three, page 225]

Location: Refer to chapter 4.10 USB Topology
Color Status Description
Yellow Off No link
Yellow Blinking Link established, activity detected
Green/Orange Off 10 Mbps
Green On 100 Mbps
Orange On 1000 Mbps
Table 15 LAN LED Description