Page 44
18 Certification Disclaimer
Both CE and FCC certifications are necessary for system level products in those countries
governed by these regulatory bodies.
Because Avnet boards are intended for evaluation kits only and destined for professionals (you)
to be used solely at research and development facilities for such purposes, they are considered
exempt from the EU product directives and normally are not tested for CE or FCC compliance.
If you choose to use your board to transmit using an antenna, it is your responsibility to make
sure that you are in compliance with all laws for the country, frequency, and power levels in
which the device is used. Additionally, some countries regulate reception in certain frequency
bands. Again, it is the responsibility of the user to maintain compliance with all local laws and
regulations.
This board should be used in a controlled lab environment by professional developers for
prototype and development purposes only. The board included in the kit is not intended for
production use unless additional end product testing and certification is performed.
19 Safety Warnings
This product shall only be connected to an external power supply that is 96boards compliant.
Only compatible plug-in modules shall be connected to Ultra96-V2. The connection of incompatible devices
may affect compliance or result in damage to the unit and void the warranty.
This product shall be operated in a well-ventilated environment. If a case is used, it shall have adequate
ventilation.
20 RF Certification
The frequency range is 2.412GHz ~ 2.472GHz (2.4GHz ISM Band).
The radio is IEEE 802.11 b/g/n (1x1) compliant for up to 72 Mbps PHY rate
The ATWILC3000-MR110CA has regulatory approval in more than 75 countries around the
world. More information on RF certification for the Microchip ATWILC3000 module is available
here:
Summary of Contents for AES-ULTRA96-V2-G
Page 10: ...Page 10 Figure 2 Ultra96 V2 Block Diagram ...
Page 26: ...Page 26 Figure 23 Connected to Ultra96 V2 Via External Wi Fi ...
Page 29: ...Page 29 Figure 28 Telemetry from PMIC 0x13 43 Figure 29 Telemetry from MPSoC Sysmon ...
Page 42: ...Page 42 7 Create or select your Host ID Click Next Figure 41 Select Host Information ...
