Basic operation
OVATION PA 8.3
| 16 |
2.7.1
Set phono mode (MM/MC)
De p end i n g o n t he c o ns t r uc t i o n p ri n c i p l e of t he
pickup system, use
MM
for electromagnetic trans
-
ducers (MM = Moving Ma gnet), or sel ect
MC
for
electrodynamic transducers (MC = Moving Coil).
Please refer to the corresponding documentation of
your pic kup system to fi nd out whether it works
according to the MM or MC principle.
Please note:
In case the output level of your
MC
system is high enough, the
MM
setting can also be
used. For fur ther information, please refer to the
operating instructions of your turntable or pickup.
2.7.2
Set phono gain
Use the
set phono gain
function to adjust the gain to
match the pickup you are using. Depending on the
output voltage of the system, a setting between 43
dB and 52 dB (with MM setting) or 63 dB and 72 dB
(MC setting) may be selected.
Please note:
Even with a 'wrong' setting, your
phono card will not be damaged. If the gain is too
high, however, an audible overload by the pickup is
possible.Please make sure to reduce the gain in this
case.
2.7.3
Set subsonic filter
The function
set
subsonic filter
offers you an optio
-
nal subsonic filter to reduce audible rumble noise in
Summary of Contents for OVATION PA 8.3
Page 1: ...OVATION PA 8 3 Operating Instructions...
Page 4: ......
