Suspend/Resume
FRITZ!Box Fon WLAN 7170 – 11 Configuration and Operation by Telephone
127
Suspend/Resume
The “Suspend/Resume” feature, also known technically as
Terminal Portability, allows you to suspend an existing con-
nection and resume it at another point on the S
0
bus. The
connection can be resumed at a different ISDN terminal de-
vice (such as an ISDN telephone) that is connected to your
BRI line along with the FRITZ!Box Fon WLAN.
To suspend a call, proceed as follows:
You will hear an acknowledgement tone to indicate that the
call has been successfully suspended. If you hear the failure
tone, this may indicate that you made a mistake, or that the
Suspend/Resume feature is not enabled on your line. It is al-
so possible that the parked-call ID you chose is already in
use.
To resume the connection, proceed as follows:
P
You are talking to Caller 1.
R
Press the Hold button. Call 1 is now suspended.
s1
PC
s
Dial the sequence shown at left. Type in the
parked-call ID as “PC”. The parked-call ID can be
any number between 0 and 99. You will need to
enter this ID again when you resume the call.
Q
O
After the acknowledgement tone, the connection
is suspended. You can hang up the handset. The
call is held at the central exchange for 2 minutes.
N
Pick up the handset again. (You must not have a
call on hold. Otherwise, FRITZ!Box Fon WLAN will
attempt to suspend it.)
s1
PC
s
Dial the sequence shown at left. Type in the
parked-call ID as “PC”. The parked-call ID is the
number you entered when you suspended the
call.
