AvL Proprietary and Confidential
Content is Subject to Change without Notice
Page
25
of
195
3.3 Network Settings
3.3.1 Factory IP Addresses
The AAQ controller provides three interfaces to the customer’s network:
Figure 3.3.1 – AAQ Controller IP Interfaces
For direct communication to the controller from a PC or Laptop, the computer attached must be
on the same network and subnet. This can be done by changing the Local Area Connection Status
(TCP/IPv4) of the Ethernet port on the user’s PC.
Figure 3.3.1b - Valid TCP/IPv4 Settings
example
The controller address can be changed through the AAQ Remote application by left-clicking the
File button on the File Bar and selecting “Settings”. The Settings window is capable of setting
the current IP address of the controller and setting a new IP address to the controller to use on
the next power cycle. The controller will accept any valid IPv4 address in the following ranges:
Figure 3.3.1c - Valid IP Address Range
Note – The Control Interface Panel display uses the 192.168.129.59 address and is
Non-Configurable.
Eth 1:0 – Interface #1, Configurable
(Factory Default IP: 192.168.129.50)
Eth 1:1 – Interface #2, Configurable
(Factory Default IP: 192.168.129.52)
Eth 1:2 – Service Interface, Non-Configurable
(Factory IP: 192.168.129.51)
Subnet mask:
255.255.255.0
IP address:
192.168.129.22 (1 to 254)
Subnet mask:
255.255.255.0
Octet Range:
1 to 255 . 0 to 255 . 1 to 255 . 1 to 255
