Page 14 of 18
10 Door Reversal
This refrigerator has been built with the door hinges on the right. If you wish to change
the opening direction, follow the instructions below:
1. Remove the upper hinge cover ( 6 ) first.
2. Remove the two screws (1) that hold the upper hinge (5) (right side) to the frame then
take away the upper hinge (5).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the two screws ( 8 ) that hold the lower hinge ( 2 ) and then remove the lower
hinge ( 2 ).
5. Remove the left front leg ( 4 ) and transfer it to the right side.
6. Move the hole cover plate ( 7 ) to the right side.
7. Before placing this lower hinge ( 2 ), remove the bolt-pin ( 9 ) and reverse the direction
of the lower hinge ( 2 ). Then install the lower hinge ( 2 ) onto the left side of the lower
frame with two screws ( 8 ).
8. Insert the bolt-pin( 9 ) into the lower hinge ( 2 ).
9. Set the door in its place making sure it sits on the door seat at the lower hinge (2).
10. While holding the door in the closed position, attach the upper hinge ( 5 ) left side of
the top frame with two screws ( 1 ), do not tighten the two screws ( 1 ) until the top of
the door is levelled to the counter top.
11. Install the upper hinge cover ( 6 ) on the upper hinge.
Before Reversal
After Reversal
