Avipas AV-1362, User Manual

Page: 64 / 65

63
6.2 Troubleshooting
1) No video output
—— a,Check whether the camera power supply is connected,the voltage is normal,the power indicator is
lit.
b,Whether the machine could do self-inspection after restarted.
c,Check whether the bottom of the DIP switch is the normal operating mode (see Table 1.2 and
Table 1.3)
d,Check whether the video output cable or video display is normal
2) No image sometimes
——a,Check whether the video output cable or video display is in a normal state.
3) Image dithering when zoom-in or zoom-out
——a,Check whether the camera installation position is solid
b,Whether there is shaking machine or objects around the camera
4) Remote controller can not work
——a,Remote control address is set to 1 (if the machine is set back to the factory defaults,remote control
addresses need to be back to 1 too)
b,Check whether the battery is installed on the remote controller or low .
c,Check the camera working mode is the normal operating mode (see Table 1.2 and Table 1.3)
d,Check the menu whether is closed,camera control through remote controller is only available
after exiting the menu.If video output from LAN,menu will not be displayed,menu will automatically exists
30s later,then it can be controlled by remote controller.
5) Serial port can not work.
——a,Check whether the camera serial device protocol,baud rate,address is consistent
b,Check whether the control cable is connected properly
c,Check whether the camera working mode is the normal operating mode (see Table 1.2 and Table
1.3)
6) Web pages can not log in
——a,Check whether the camera is showing normally.