- 10 -
3. Setting up your device
3.1 Before Starting
*Before setting up the device make sure of the following:
1.)
All the package contents are all included if anything is missing please contact the dealer
where the device was purchased from.
2.)
Check the power input cable is working correctly.
3.)
Check all cables to make sure there are no problems with it.
3.2 Hardware Connection
Please refer following procedure :
1.) Connect the Ethernet cable (RJ45) to the 9858MT to your local area network.
2.) Then connect the power cable into the power input port of the 9858MT.
3.) Connect the device that you would like to control to the output plug on the top of the 9858MT.
4.) Switching the power source to ON status , this switch is located at the rear of 9858MT.
5.) After power on for around 45 seconds , there is a short beep sound for 9858MT which
means the system reboot successfully
6. ) Go to page #14 for software installation guide
– use IP EDIT to log in the webpage of
9858MT.
3.3 Software Installation
Please Go to
. The note with this online CD link comes with
the package .
IP Power Software:
IP Edit ( Required)
IP Power Center *(
For multiple IP Power devices control purpose )
