Avidyne 700-00004 Series, Installation Manual, Page: 88 / 132

EX5000 Installation Manual
P/N 600-00073 Rev 24
- 78 -
5.11.6 Checklists Setup (Cirrus & Columbia Only)
EX5000 MFDs in Cirrus & Columbia aircraft support Checklists. If Checklists are available for this
aircraft, the Checklist pull-down will be available from the Aircraft Setup Page.
Use the Checklist pull-down to select the appropriate aircraft and serial number range. Checklists are
only available for aircraft listed in the Checklist pull-down.
Note:
This option is only available with software part numbers 530-00117-000, 530-00130-000, 530-
00148-000, 530-00162-000/002, 530-00180-100/200, 530-00195-100/110/210, and 530-
00201-100/200.
Note:
The current revision of the installed checklists will appear on the splash screen on restarting
the MFD. If you modify the Checklist settings in the Aircraft setup page, restart the MFD and
observe the splash screen to verify the current revision of the Checklist.
Note:
If you are using an OEM-supplied build of Checklist Loader, follow the instructions in the
manual, “Multi-Function Display Checklist Editor - User’s Guide” (600-00144-000, Latest
Revision).
5.11.7 Dimming Bus Setup
On all aircraft, you can configure the LEDs on the bezel to better match the other cockpit instrument
lights on the aircraft dimming bus.
➤
To set the dimming bus:
1. Highlight the Brightest dimming voltage selection. An additional button, Set Voltage, appears
below the Save button.
2. Adjust the Airplane dimming bus (usually a knob) to the full bright level. Monitor the dimming bus
voltage on the MFD below the selection boxes. When at full bright, press
Set Voltage to update the
highlighted field.
3. Highlight the Darkest dimming voltage selection and adjust the airplane dimming bus to a level so
that the other cockpit instruments are at their lowest brightness level.
4. Press Set Voltage again to update the Darkest dimming voltage field.
5.11.8 Dimming Bus Checkout
Restart the MFD. Adjust the aircraft dimming bus and verify that the MFD bezel LEDs match the rest of
the cockpit instrument lamps and lights.
!
Caution : The checklist function is only authorized for use specifically with the aircraft
types that are listed on the Aircraft Setup page. Do not select any aircraft type that
does not match the installation aircraft. If the installation aircraft type is not listed as
a checklist option on the Aircraft Setup page, then the checklist function is not available
for that aircraft.
Selecting an inappropriate aircraft type can lead to incorrect
operation of the aircraft by the pilot .