Avidyne 700-00004 Series, Installation Manual, Page: 46 / 132

EX5000 Installation Manual
P/N 600-00073 Rev 24
- 36 -
Figure 8: GPS Setup, GAMA 429
2. Configure the following:
■
Receiver —Select GAMA 429 Graphics Format.
■
Port— Select ARINC1.
Note:
Selecting Port=None indicates that a GPS is not connected to the MFD. In this case, the MFD
software does not expect GPS input.
■
Speed— There are two speeds available, High and Low. See Table 16, “GPS/FMS
Manufacturer’s Matrix,” on page 39 to determine the correct speed for your system.
3. When you are done, press Save to save your changes. Press Cancel to exit without saving
changes.
4. Changes do not take effect until the MFD has been restarted. From the Maintenance Mode Page,
press
Restart System .
5.5.2 Dual GPS Setup with GAMA 429
The EX5000 can receive information from two GAMA 429 Graphics capable GPS units. Connect the
GPS according to the wiring diagram in Appendix J:
Wiring Diagram – GPS/FMS , using a different
ARINC port for GPS2. Follow the setup instructions in Section 5.5.1.