Chapter 9: Outputs and Output Routing
77
Output Delay
A variable delay can be applied to any of the Main busses (L, R
and C/M), Aux bus outputs, and Matrix mixer outputs.
To apply delay to an Aux bus:
1
Target the Aux bus by pressing its Select switch.
2
Press the Channel Control Input switch.
3
Press the Delay rotary encoder to engage the delay.
4
Adjust the delay value by turning the Delay rotary encoder.
The amount of delay available depends on the type of output,
as follows:
• Up to 500 ms for Mains and Matrix mixers
• Up to 250 ms for Aux Sends
Adjusting Main Bus Controls
Main Bus Output Levels
The Main bus output levels are controlled from the single
Mains Fader located to the right of the Output faders.
The Left, Right, and Center/Mono busses can be controlled in-
dependently or in tandem. You can create an offset between
any of the Main bus levels, and it will be preserved when con-
trolling any combination of the Main busses. The offset be-
tween the busses is maintained until at least one of the busses
is minimized or maximized.
Linking Mains
You can link any of the three Mains faders for grouped-control
of level and mute.
To control the Main bus output levels:
1
In the Outputs page, click the on-screen channel
Link
but-
tons for any combination of Left, Right, or Center/Mono out-
put strips to assign control of the corresponding busses to the
Mains Fader.
2
Move the Mains fader to change the level of the assigned
busses.
Main Bus Mute
The mute status of the Main busses is controlled from the
Mute switch located above the Mains Fader. When at least one
of the Main busses is muted while others (unlinked) are not,
the Mains mute switch flashes.
To control the mute status of the Main busses:
1
In the Outputs page, click the on-screen channel Link but-
tons for any combination of Left, Right, or Center/Mono out-
put strips to assign control of the corresponding busses to the
Mains Fader.
2
Press the Mute switch to toggle the mute status of the as-
signed busses.
Main Bus Delay
A variable delay (from 0 to 500 ms) can be applied to any of
the Main busses.
To apply delay to a Main bus:
1
Target the Main bus where you want to apply delay by re-
peatedly pressing the Select switch in the Mains section, or by
selecting it on-screen.
2
Press the Channel Control Input switch.
3
Press the Delay encoder to enable delay.
4
Adjust the Delay value by turning the on-screen Delay ro-
tary encoder.
Mains Fader and controls in the Output section
Select
Mute
Fader
Mains fader Link selectors in the Outputs page
Link
courtesy of
www.sxsevents.co.uk
Phone: 0870 080 2342
email: [email protected]
Event production and Audio-Visual Services
www.sxsevents.co.uk
