VENUE SC48 Guide
118
Routing the Oscillator
The output of the internal oscillator can be routed to Input
Channels, FX Returns, or any of the output busses. The Oscil-
lator provides selectable signal type, frequency (for Variable
Sine) and signal level, as well as a master on/off switch.
Configuring the Oscillator and Setting Level
To activate and set the level for the oscillator:
1
Go to the
Options > Misc
page.
2
As a precaution, click and drag the on-screen
Level
encoder
down to set the Oscillator level to off before you go any fur-
ther.
3
In the
Oscillator
section, click the
Signal
pop-up and select
from the following signal types:
• 100 Hz Sine
• 1 kHz Sine
• 10 kHz Sine
• Variable Sine
• Pink Noise
• White Noise
4
If you select
Variable Sine
, you can set the sine wave fre-
quency with the on-screen frequency control (directly to the
right of the
Signal
pop-up).
5
Click the on-screen
In
button in the
Oscillator
section.
6
Set oscillator level by slowly raising the on-screen
Level
en-
coder.
To assign the Oscillator signal to an output bus:
1
In the
Options > Misc
page, click the
Route
button in the
Os-
cillator
section.
2
Do either of the following:
• If you had already selected the desired output, click to
confirm the currently displayed Route To mode (in the
lower left corner of the screen).
– or –
• Go to the Outputs page and click to select an output (it
flashes briefly).
3
In the confirmation dialog that appears, click
Route
to con-
firm your assignment or click
Cancel
to cancel without chang-
ing the current routing.
Talkback, 2-Track and Oscillator States When
Loading Shows
When you load a Show file, Talkback, 2-Track and Oscillator
controls are set to off (deactivated), regardless of their state
when the Show was last saved.
Oscillator controls in the Options > Misc page
Signals are routed to output busses post-mute and post
fader.
courtesy of
www.sxsevents.co.uk
Phone: 0870 080 2342
email: [email protected]
Event production and Audio-Visual Services
www.sxsevents.co.uk
