—
1/28/19
5
Stage 32
This section shows you how to attach the included rack ears to the VENUE | Stage 32 I/O rack to mount the rack into a flight case, fur-
niture or other rack housing.
The ears can be installed on the front or the back of the rack depending on the desired orientation. The front of the rack is where all the
I/O connectors are located, and the back of the rack is where the power switches and associated AC connectors are located.
Components
Mounting the Stage 32 utilizes the following components:
• (2) Stage 32 rack ears
• (16) Rack ear mounting screws (eight per rack ear) and washers
The included rack ears can be installed on the front or the back of the Stage 32. The front of the rack is where all the I/O connectors are
located, and the back of the rack is where the power switches and associated AC connectors are located.
To attach the rack ears to Stage 32:
1
Locate the rack ears and the rack ear mounting screws, included in the Stage 32 box.
2
Position one of the rack ears at the front or back of the rack.
3
Using a #2 Phillips screwdriver, insert 8 of the included M4X10 rack ear screws with washers in the positions indicated in the figure
below, and tighten to secure the rack ear to the rack.
4
Repeat for the other side.
Avoid overheating. Be sure to maintain proper air ventilation when installing the device in a rack, and do not block the Stage 32 fans
while operating the device.
Attaching rack ears to the front of Stage 32
