Recovering from Stacking Problems
141
The switch and storage blade password is
se-admin
and the System Director password is
is-admin
.
8. The switch restarts.
When the switch starts up, it has IP address “192.168.10.26” and the password is reset to
default.
9. If the problem switch is an:
-
IXS — Click Add from another IXS. If there is not another IXS, click Add from another
ISS.
-
ISS — Click Add from the IXS to which this switch will connect.
10. Connect the interconnect cable from the problem switch to the IXS.
-
If the problem switch is an IXS, connect an interconnect cable to another ISS.
-
If the problem has been resolved, connect the interconnect cable from the switch on the
other VLAN subnet to the IXS on fixed subnet. If the problem switch was an IXS,
re-connect all other interconnect cables in the engine.
Rebuilding the Stack
The following procedure summarizes how to rebuild the entire stack of engines.
To rebuild the stack:
1. Disconnect all interconnect cables between all switches.
2. Pull each switch by removing them from the engine.
This clears any traffic loop problems.
3. Reseat the first IXS in the engine and connect through the management port of the first IXS.
4. Use the management IP address to access the switch’s Agent Page (for example
https://192.168.0.10:5015/).
5. Navigate to the Advanced Web page.
6. Under Switch Blade, click “Reset to factory defaults.”
n
The switch and storage blade password is se-admin and the System Director password is
is-admin. The System Director Web Page Administrator default password is blank.
7. Enter the password when prompted to reset the switch to defaults.
8. The switch restarts.
