Installing the Engine Controller
51
3. Repeat this procedure to install the second power into the second power supply slot.
Installing the Engine Controller
This section describes how to install the Engine Controller.
n
The Engine Controller must be in the left slot (when viewed from rear of Engine). The software
does not run if Engine Controller is in the right slot.
To insert an Engine Controller:
1. Position the Engine Controller so that the release latch is at the bottom.
2. Open the release latch and rotate it to its most open position.
3. Slide the Engine Controller into its slot until it will go no further.
4. Close the latch until it clicks in place. This will lever the module into its connector on the
midplane. The Engine will automatically detect the new unit.
n
The Engine Controller shown in the illustration is for reference only, the actual Engine
Controller used in the ISIS 2000 Engine varies from the model shown in the picture.
Summary of Contents for ISIS 2000
Page 1: ...Avid ISIS 2000 Setup Guide...
