Installing the Media Drives
48
Installing the Media Drives
This section describes how to install a media drive. The procedure for installing the media drives
is the same for both drawer 1 and drawer 2. The location on where the media drives get installed
is different between the two ISIS 2000 Engine configurations.
•
ISIS 2000-240 Media Drive Configuration (1 Engine, with 82 drives) — There are 41 drives
in each drawer.
•
ISIS 2000-120 Media Drive Configuration(1 Engine, with 42 drives) — There are 28 drives
installed in the front-most slots of the top drawer. The last 14 drives are installed in the
front-most slots of the bottom drawer.
c
The ISIS 2000-120 media drive configuration is mandatory. You must install the drives in
the slots specified, This is an air-flow requirement and is enforced with the software.
To insert a media drive:
1. Make sure the anti-tamper locks are not engaged. The red arrows on the locks will point
inwards if the locks are disengaged. Unlock them if necessary by rotating them
counterclockwise using a screwdriver with a torx T20 bit.
2. If the appropriate drawer is not already open, open it using the instructions in section
Opening and Closing the Media Drive Drawers.
3. Lower the Media Drive into the slot, with the drive capacity label facing towards you.
Summary of Contents for ISIS 2000
Page 1: ...Avid ISIS 2000 Setup Guide...