Engine Controller Replacement
166
To insert a power supply:
1. Position the power supply so that the red release latch and handle are on the left-hand side.
2. Slide the power supply into its slot until the latch clicks in place. The Engine will
automatically detect the new unit.
Engine Controller Replacement
This section describes how to replace the Engine Controller. If the Engine Controller has failed,
the fault LED will be lit red.
n
You should have a replacement module to insert before removing a module. When the Engine
power is left on, a new Engine Controller should be inserted within two minutes of the removal of
the defective Engine Controller.
Summary of Contents for ISIS 2000
Page 1: ...Avid ISIS 2000 Setup Guide...
