Management Console Error Messages
154
To check for poorly performing disks:
1. Open Storage Manager Agent.
2. Click Statistics > Storage Manager > Disk.
Invalid Number of Disks Message
The “Invalid number of disks” status is an indication that the Storage Manage does not see the
correct number of RAID arrays (or disks) for the Storage Manager.
To check the RAID configuration:
1. Open Storage Manager Agent.
2. Click Advanced > RAID Diagnostics.
t
Click Verify RAID Config.
t
Click Show RAID Config.
t
Click Show RAID Status.
Depending on your ISIS 2000 Engine configuration you should have four or eight arrays.
If you do not have the correct number of arrays, make sure all drives are there (and in the
correct slots for the ISIS 2000 configuration) You might need to do use the “Delete and
Recreate” command in the Advanced tab to recover once all drives are available.
No RAID Arrays Exist
The RAID sets should be configured on install. The reason this might not have happened is that
some or all of the drives were not present at install time.
To manually build the RAID sets:
1. Open Storage Manager Agent.
2. Click Advanced > Destructive RAID Tools > Delete and Recreate.
3. Enter password and click Recreate.
The RAID sets start rebuilding and restarts the Storage Manager.
Not All RAID Arrays Are Active
In most cases the array attempted to start but could not and is left in an “inactive” state. This
typically happens if multiple drives are not available at startup or all disconnect at the same time.
In most cases restarting the offending arrays fixes this problem. To recovery from this is to use
the “Repair Config” button.
Summary of Contents for ISIS 2000
Page 1: ...Avid ISIS 2000 Setup Guide...
