31
n
When you are installing drives in the Avid FastServe | Live Edit or FastServe | Ingest server, begin
the installation at the bottom of a column of drives. Make sure the first drive you install is level and
flat as you insert it into the server.
c
Do not
force a drive into a slot. If you are having problems installing a drive, check to make
sure it is level and flat as you insert it into the server, that the drive carrier latch is open and at
a 45 degree angle to the drive carrier, and that the LEDs are on the bottom of the drive carrier.
5. Slide the drive into the open drive slot in the server until it stops. Approximately 1/2 inch of the
drive carrier should be outside the server.
6. Push the handle into the drive carrier. This seats the drive in the server. You’ll hear a click when
the drive is fully seated and the handle latches in place.
7. Repeat steps 2 to 6 for the remaining drives.
Cabling the Server
Once the FastServe | Live Edit or FastServe | Ingest server is securely installed in the rack, and the
drives are installed, you are now ready to connect the appropriate cables to the rear panel of the
server to the external devices for your particular site. This section contains the cabling diagrams and
instructions for your FastServe | Live Edit or FastServe | Ingest server.
c
Do not connect the FastServe | Live Edit or FastServe | Ingest server to your Avid NEXIS
environment until you have assigned it a new unique IP address.
Summary of Contents for FastServe Ingest
