Avid Technology AirSpeed series, Installation And User Manual

Page: 49 / 282

Unpacking and Inspecting Your System
49
Verifying Components
Once you have unpacked everything, verify that you have the following boxes or
components:
• AirSpeed Multi Stream chassis
• Media drives (4 per system)
• Expansion Port cables (one cable for SD and DNxHD models, two cables for MPEG-2
HD models)
• Power cables (2 per system)
• USB Flash Drive (UFD)
• Rack mount supports, ear covers, clips and screws. For more information, see
“Rack-mount Kit Contents” on page 51 .
• Service ID card
• Health and Safety Guide
n
ReadMe files are not in the box. They can be found in your Avid application folder as a PDF
document (ReadMe.pdf) and are also available online. You should always check online for
the most up-to-date release notes or ReadMe because the online version is updated
whenever new information becomes available. To view these online versions, visit the
Knowledge Base at www.avid.com/readme.
If you are missing any of these components, contact Avid Technical Support before
proceeding.
Inspecting Components for Damage
Once you have verified that all of your components have been shipped, you must verify that
they are not damaged.
To inspect components for damage:
1. Visually inspect all of the hardware components listed in the section on the previous
page to make sure that none of them were damaged during shipment.
2. If you received a hardware component that was damaged, contact Avid Technical
Support.