AirSpeed Multi Stream Configuration
113
Configuring General Purpose Interface (GPI) Inputs and Outputs
This topic contains information on how to configure General Purpose Interface (GPI) Inputs
and Outputs in AirSpeed Multi Stream.
To configure General Purpose Interface (GPI) Inputs and Outputs:
1. Make sure that GPI triggers are enabled in AirSpeed Multi Stream. This is done by
selecting File > Preferences > Enable GPI Triggers.
A check mark indicates that GPI triggers are enabled in AirSpeed Multi Stream.
Summary of Contents for AirSpeed series
