Avid Technology AirSpeed Multi Stream, Installation And User Manual

Page: 144 / 398

4
Configuring the Software in a Workgroup Environment
144
Selecting Default Templates
Use the Default Templates tab to select the Record template, proxy resolution, and
Destination template for each channel you are going to record.
To select default templates:
1. Click the Default Templates tab. The Default Template tab opens. The following
example shows the Default Templates tab as it would appear on an AirSpeed Multi
Stream system that has H.264 proxy capabilities. Notice the Proxy column in the center
of the tab.
2. (Option) For each channel, select the Record and Destination template that best fits your
site’s requirements. This is done by doing the following:
a. In the Record column, in the Channel 1- Channel 4 fields, select the Record
template for the high-res resolution.
n
For each channel, the Record drop-down list contains all supported Record templates based
on the video standard (NTSC, PAL, 1080i or 720p) of the channel.
n
Every time you switch the video standard of the channel (for example, from NTSC to 720p,
or from 720p to 1080i59.94), the Record template is set back to None by default. You have to
reconfigure it by setting the format Default Teplates as shown below.
b. (Option) Below the Record Templates for channels 1-4, select a default setting for
each format. The formats are displayed in the following Format Default Template
fields:
t
NTSC or PAL (for SD)