Aviat Networks ECLIPSE EDGE, User Manual

Page: 89 / 274

260-668080-001 Rev 002 March 2013 43
Eclipse Edge User Manual
Setting ATPC
This procedure is based on the prevailing path conditions being typical during the
setup procedure, that is, not subject to rain fade or other fade conditions and assumes
the Target Fade Margin is the primary driver for establishing the settings.
The objective is to check that Remote Fade Margin and the Detected Tx Power are
/- 3 dB of the planned figures for the link, and that there is appropriate Tx
Power headroom for correct ATPC operation.
Figure 4-8.
Example ATPC Settings
Table 4-7.
ATPC Functions and Descriptions
Item Description
1 Set the fade margin for the
remote end
2 Calculated remote end fade
margin
3 Set maximum local end Tx power
4 Set minimum local end Tx power
5 Detected local end Tx power
6 Mouse-over for tooltip advice
1
2
3
4
5
6
Function Description
Target Remote Fade Margin
This is the desired fade margin for the remote-end ODU.
Depending on the path design this should be set at a level
which will allow head room for the local Tx power, while
ensuring an adequate fade margin.