AVG-SC41T-CODEC
4. Operation
4.1. Front Panel Control
Front panel buttons can be used for switching operations, OSD and volume control.
4.1.1. Manual Switching
Press the
SOURCE/AUTO
button to select an input for the Transmitter, press again
to select next source, switching sequentially between 1-HDMI, 2-HDMI, 3-DP and 4-
VGA. The corresponding LED will illuminate green.
The Receiver also features one HDMI input port, if you need to output the source
signal via its HDMI output port. The following is an example.
LED Status
Description
Status
1
The 1-HDMI LED illuminates
green, other source LEDs are
gone.
The 1-HDMI is selected as input
source. The input signal will be
transmitted to all video output
ports of Transmitter and
Receiver.
Status
2
The 2-HDMI and RX HDMI LEDs
illuminate green, other source
LEDs are gone.
The 2-HDMI is selected as
input source for Transmitter.
The input signal will be
transmitted to all video
output ports of Transmitter.
The HDMI input signal on
Receiver will be only
transmitted to the HDMI
output port of Receiver.
Follow the below steps to switch to the status 2 from status 1.
①
Press the
SOURCE/AUTO
button once to select 2-HDMI, and then release this
button.
②
Press the
SOURCE/AUTO
button continuously until the RX HDMI LED
illuminates green to select the HDMI input for Receiver.
RX HDMI
SOURCE
AUTO/3s
1-HDMI 2-HDMI
4-VGA
3-DP
RX HDMI
SOURCE
AUTO/3s
1-HDMI 2-HDMI
4-VGA
3-DP
