EZTouch I/O
Jr.
42 / 52
Display Verification Tests
The
EZTouch I/O
Jr. allows for you to run display verification tests in the field that can
check the pixel display and the response of the touchscreen interface. Follow the
steps outlined below to utilize these tests.
First, simultaneously press the upper left corner and the bottom left corner of the
screen to reach the language selection screen. After selecting the appropriate
language for the unit, the unit will then enter the Setup Mode. The screen below
will appear displaying the current firmware, the available memory as well as the
time and date set on the unit.
To test the touchpad response
:
1. Press the
Touchpad Test
button.
2. A new screen will appear. Press each box individually to ensure that the
touchscreen is properly responding.
3. Once finished, press
Exit
to return to the previous screen. Pressing
Exit
again
will bring you back to the main screen.
To test the pixel display
:
1. Press the
Display Test
button.
2. The screen will then automatically go through a variety of colors. Verify if all
elements of the screen are lighting up appropriately.
3. Once finished, press
Exit
to return to the previous screen. Pressing
Exit
again
will bring you back to the main screen.
Summary of Contents for EZTouch I/O Jr.
