Avery Dennison Monarch 2, Programmer'S Manual

Page: 26 / 234

Always include an I , immediately after the left bracket { and
before the packet identifier (A, B, C, etc.). The
I
parameter
identifies the data stream as a configuration packet.
Include the
I
parameter with each packet if
you are sending them individually. Include it
only at the beginning of a data stream if you
are sending multiple packets.
This is the syntax to use when you create online configuration
packets:
Syntax
{
Start of Header
I
,
Configuration Header
1 - 8 optional records
A, parameter 1...parameter 5
p System Setup
B, parameter 1...parameter 5
p Supply Setup
C, parameter 1...parameter 5
p Print Control
D, parameter 1...parameter 3
p Monetary Formatting
E, parameter 1...parameter 9
p Control Characters
F, parameter 1...parameter 5
p Communication Settings
G, parameter 1...parameter 4
p Backfeed Control
M, parameter 1...parameter 4
p Memory Configuration
}
End of Header
Syntax for single packet
{
Start of Header
I
,
Configuration Packet Identifier
A, parameter 1...parameter 5
System Setup
}
End of Header
You can also add a configuration to non-volatile RAM or specify
units for supply, print, margin, and cut positions. If you use the
optional parameters with the
I
packet, any online configuration
packets following the split vertical bar ( p ) must specify distances
using the selected units. However, the diagnostic labels display
the units in dots, even if you entered them in English or Metrics
units.
2-6 Configuring the Printer