89
5.3 A
PPLICATOR
O
PERATION
ALS
20X
256
[94] ALS 20x with LA-TO (A), LTP (B) and LA-BO (C). The pictures don´t show any cables, hoses or safety guards.
5.3.1
Function
In order to match applications, which do not allow direct
labelling from the dispensing edge onto the product, the
labeller can be equipped with an applicator. The appli-
cator bridges a certain distance between dispensing
edge and product. In applicator operation, the applica-
tor takes the label over from the dispensing edge and
transfers it to the product.
5.3.2
System requirements
The following applicators are available for the
ALS 20x/256:
– LA-TO (tamp-on applicator) [94A]
– LTP/LTPV (tamp-on applicator for variable product
heights and/or sensitive products) [94B]
– LA-BO (blow-on applicator) [94C]
WARNING!
Danger of crush injuries at LTP/LTPV and
LA-TO.
Only operate LTP/LTPV and LA-TO with
higher-level protective equipment (see
service manual LTP/LTPV or service ma-
nual LA-TO).
The applicators are controlled via one of the following
interfaces:
– Standard signal interface
(see
Kap. 7.5.3 (S. 142)
)
– optional applicator interface
(see
Kap. 7.7 (S. 160)
)
5.3.3
Assembly and operation
Assembly and operating instructions regarding the ap-
plicators can be found in the following manuals:
– LA-TO service manual
– LA-BO technical manual
– LTP/LTPV service manual
A
B
C
5.3
APPLICATOR OPERATION
Summary of Contents for ALS 204
Page 1: ...ALS 204 206 256 SERVICE INSTALLATION MANUAL Labeller Edition 8 3 2012 Original version ...
Page 2: ......
Page 223: ......
