72
5.3 Recording
Setting
In the Recording dialog box, click
OK
to accept the new settings, click
Cancel
to exit without
saving, and click
Default
to revert back to original factory setting.
(10)
(11)
(9)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(1) Camera Icons
Select the camera number you want to set the recording setting. To select all the cameras,
enable the
ALL
check box. To select more than one camera,
Right click
on the camera icon.
To select one camera only,
Left click
on the camera icon. The camera icon turns red when it
is selected.
(2) Recording Mode
The horizontal blocks from 00 to 23 represent the time in 24-hour clock and the vertical block 1
to 7 represent the day in the week block (Sunday to Saturday). To record in full 24 hours and 7
days a week, select the recording mode and click the
~
button. If you want to only record at a
particular time or day, click
Schedule
button and select the
Recording Mode
, and then click
on the time or day blocks. When the system starts recording a red triangle mark would appear
at the upper left corner of the screen. The recording modes are listed below:
-
Always Recording
Record the video from the selected camera and save it to the designated storage path
(see also
).
-
Motion Recording
Start recording the video from the selected camera only when the system detects
movement. Once a motion is detected, the system automatically saves the previous
frames and stop based on the
Start Record Prior
and
Stop Record After
settings.
-
Smart Recording
Automatically switch to recorded at the maximum frame rate setting once a motion is
detected and if there is no motion, it records at the minimum frame rate setting. Set the
maximum frame rate setting in
.
-
Voice Detecting Recording
DVR system will record when the voice exceeds the intensity value in
Voice Detection
setting.
