AVer TR313V2, User Manual

Page: 51 / 66

43
3.
Tracking Sensitivity: Set the sensitive level of tracking. Move bar to set the value. The current
value is displayed at upper right corner.
4.
Time of Return to Tracking Point: Set the idle time for camera return to tracking point. Move bar
to set the value. The current value is displayed at upper right corner.
[Note]
Quick setup for zone mode
2 blocks initially selected and preset 6 is the initially start position. However, if you prefer 3 or 4 blocks
for Zone mode tracking and prefer another preset as start position, go to web setting.
1.
Use IR remote to adjust the camera view properly then save to preset6, preset7.
2.
Long press “Tracking Point” to switch tracking mode from Presenter Mode to Zone Mode
(the hotkey supported at firmware v0.0.0000.21 or later).
3.
Press “ON”, here you go!
Hybrid Mode
This function allows the user to use two types of tracking modes: “Presenter mode” and “Zone mode”
at the same time. When the presenter enters selected preset points, it will change to Zone position;
when the presenter leaves the preset points, camera will follow presenter to do Auto Tracking function.
1.
Mix two tracking modes “Presenter” and “Zone” at the same time. For Hybrid mode, do not set
Zone preset points overlapping or close to each other. It is recommended to leave some distance
between Zone preset points.
2.
Use direction control panel to move the camera to desired position and select “save” to save the
preset position. And, a snapshot of the preset image will show at corresponding image display
box. Select preset position and select “Delete” to delete the saved preset position (Preset 10, 11,
12, and 13).