9
Remote Control
The remote control requires two
“AAA” batteries. Make sure batteries are installed properly before use.
Name
Function
Model: LY033
1. Power
Short press to turn on/off the Standby mode.
2. Home
Move the camera to the Home position.
3. Number
Buttons
Press buttons 0~9 to move the camera to the
pre-configure preset positions.
Use the buttons to set up preset positions 0~9.
4. Preset
Use the Preset, Number and Direction Buttons to
set up preset positions.
a. Use the Direction Buttons to navigate a
position. Optionally use the
“Zoom +” or “Zoom
-
” buttons to zoom in/out the image.
b. Press Preset and then press the Number
Buttons (0~9) to save this preset position.
5. Zoom +/-
Press to zoom in or zoom out the images.
6. MIC
Press to mute the microphone. Press again to
unmute.
7. Camera
Select
CAM1 to CAM4 buttons. Select a camera to
operate. To set up camera ID, refer to
Camera
Selector
in the <OSD Menu Tree> chapter.
8. Remote
Control
LED
When pressing the buttons on the remote control,
the LED will light red.
9. Menu
Press to enter or exit the OSD menu.
10. Snap
Press to take a snapshot image. The images will
be stored in the microSD card.
11. Rec
Press to start recording to the micro SD card.
Press the button again to stop recording.
12. Reset
Use the Reset and Number Buttons to cancel a
pre-configured preset position. Press Preset and
then press the Number Buttons (0~9).
13. Direction
Buttons
Use the Direction Buttons to navigate the live view.
14. /-
Press to adjust the volume up or down.
15. Enter
Access the OSD menu, confirm the selection or
make a selection in OSD menu.
16. Speaker
Press to mute the speaker. Press again to unmute.
17. Privacy
Press to enter the Privacy mode. The camera will
move to the Privacy position and microphone will
be off.
HOME
REC
SNAP
MIC
PRIVACY
SPEAKER
X
1
2
3
4
5
7
6
14
9
10
11
12
16
17
15
13
8