Aventics Marex 3D 531, Assembly Instructions Manual

Page: 7 / 28

Safety instructions
AVENTICS | Joystick Type 531 | R417003072–BDL–001–AA 7
Eng
lish
1.3.4 Abbreviations
The following abbreviations are used in these assembly
instructions:
1.3.5 Measuring units
If not stated otherwise, the dimensions in this document are in
mm.
2 Safety instructions
2.1 About this chapter
The Joystick Type 531 has been manufactured in strict
compliance with the generally accepted rules of technology.
However, this does not exclude the risk of damage to persons or
property if the general safety instructions in this chapter and
the safety instructions in this document are not observed.
O
Read these assembly instructions completely and carefully
before mounting the Joystick Type 531.
O
Keep these assembly instructions in a location where they
are accessible to all users at any time.
O
Always include these assembly instructions when passing
the Joystick Type 531 on to third parties.
2.2 Intended use
The Joystick Type 531 is used to control ship propulsion
systems and thrusters. It is designed for boats, yachts and small
commercial vessels for in- and outdoor application. The
Joystick Type 531 must only be operated with Marex 3D under
the conditions described in these assembly instructions and
under observance of the instructions for the Marex 3D system.
Table 5: Abbreviations
Abbreviation Meaning
CAN Controller Area Network
Asynchronous serial bus system to link control units.