11
5
.2.
2.
Cutting material
1) Place the device on a stable, level surface with the cutting head facing up.
2) Slide the cutting head to one side of the guide rail.
3) Slide the material to be cut under the transparent pressing rail at the required position.
Note:
Observe the permissible quantity of material which may be cut, refer to Chapter
“Intended Use” or “Technical Data”.
Note:
The visual positioning aids simplify correct alignment of the material to
be cut.
4) Hold the material to be cut firmly with one hand so that it cannot slip when cut.
Otherwise, the cut may be inaccurate.
5) To complete the cut, press the cutting head down and slide it along the
guide rail to the other side.
Note:
To prevent a faulty cutting edge, do not run the cutting head back again
but remove the cut material directly after completing the cut.
