Avaya X330W-2DS1, User Manual, Page: 77 / 176

General: Device Commands
Avaya X330W-2DS1 User’s Guide 55
Output Example:
To add an entry in the SNMP trap receiver table with default:
X330WAN-2DS1-1(super)# set snmp trap 192.168.173.42
SNMP trap receiver added.
set snmp trap auth
Use the
set snmp trap auth
commands to enable/disable the sending of
SNMP traps upon SNMP authentication failure.
The syntax for this command is:
set snmp trap
{enable|disable}
auth
Output Example:
X330WAN-2DS1-1(super)# set snmp trap enable auth
Authentication trap enabled
set system contact
Use the
set system contact
command to set mib2 system contact MIB
variable.
The syntax for this command is:
set system contact [contact string]
Example:
set system contact "Gabby ext.545"
set system location
Use the
set system location
command to set the mib2 system location MIB
variable.
contact string Contact person. The contact person field is cleared if this field is
blank. A string of 2 words or more must be type in quotation
marks – e.g. “Yigdal Naouri”.