Avaya X330W-2DS1, User Manual, Page: 158 / 176

Chapter 7 X330WAN CLI Commands
136 Avaya X330W-2DS1 User’s Guide
loopback remote {line|payload}
Example:
X330WAN-2DS1-1(config-controller:1)#loopback remote line
mtu (Serial interface context)
Use the
mtu
command to set the interface Maximum Transmission Unit (MTU). Use
the
no
form of this command to restore interface MTU to the default value (1500).
The syntax for this command is:
[no] mtu <size in bytes>
Example:
X330WAN-2DS1-1(config-if:Serial1:1)# mtu 1000
no channel group (Controller context)
Use the
no channel group
command to delete a channel group.
The syntax for this command is:
no channel-group <channel-num>
Example:
X330WAN-2DS1-1(config-controller:1)# no channel-group 2
no loopback (Controller context)
Use the
no loopback
command to disable the loopback mode.
line The controller loops the external line signal back toward the
network without reframing the DS1 signal.
payload The controller loops the external line signal back toward the
network and reframes the DS1 signal. (This option is available
in the framing esf mode and only when fdl is defined.)
size in bytes Range from 64-1500
channel-num ID number to identify the channel group. The valid
range is from 0 to 23 for T1 lines and from 0 to 30 for
E1 lines.