Avaya X330W-2DS1, User Manual, Page: 152 / 176

Chapter 7 X330WAN CLI Commands
130 Avaya X330W-2DS1 User’s Guide
The syntax for this command is:
[no] fragment timeout <timeout>
Example:
X330WAN-2DS1-1(configure)# fragment timeout 30
framing (Controller context)
Use the
framing
command to select the frame type for the E1 or T1 data line. Use
the
no
form of this command to set the controller’s framing type to the default
value.
The syntax for this command is:
For T1 lines:
[no] framing {sf|esf}
For E1 lines:
[no] framing {crc4|no-crc4}
Note: Use this command in configurations where the router or access server is
intended to communicate with E1 or T1 fractional data line. The service provider
determines which framing type (
sf
,
esf
, or
crc4
) is required for your E1/T1
circuit.
Example:
The following example selects extended super frame as the T1 frame type:
X330WAN-2DS1-1(config-controller:1)#
framing esf
timeout An integer (5-120). The maximum number of seconds to re-
assemble an IP packet. The default is 10.
sf Selects Super frame framing (dsx1D4). This is the default value
for T1 lines.
esf Selects Extended super frame framing (dsx1ESF).
crc4 Selects CRC4 framing. (dsx1E1-CRC-MF). This is the default
value for E1 lines.
no-crc4 Selects no-CRC4 framing (dsx1E1-MF).