Avaya X330W-2DS1, User Manual, Page: 151 / 176

WAN CLI Commands
Avaya X330W-2DS1 User’s Guide 129
Note:
1. This command can only be performed if the controller is set to T1.
2. Use this command only when framing esf is defined.
The syntax for this command is:
[no] fdl <fdl-mode>
Example:
X330WAN-2DS1-1(configure)# fdl ansi
fragment size
Use the
fragment size
command to set the maximum number of fragmented IP
packets, destined to the router, to reassemble at any given time. Use the
no
form of
this command to set the fragment size to the default value (100).
Note: No fragmentation will be done of packets in transit through the router.
The syntax for this command is:
[no] fragment size
<database-limit>
Example:
X330WAN-2DS1-1(configure)# fragment size 150
fragment timeout
Use the
fragment timeout
command to set the maximum number of seconds to
reassemble a fragmented IP packet destined to the router. Use the
no
form of this
command to set the fragment timeout to the default value (10).
Note: No fragmentation will be done of packets in transit through the router.
fdl-mode
ansi | att | both
database-limit The maximum number of packets undergoing re-assembly at
any given time. The default is 100.